KETCH005- 非金属地面硬化剂（金刚砂耐磨地坪）
|
|
|
|
|
| |
| 用 途 (Uses): |
| |
| |
菲凡士金属地面硬化剂为整体地坪提供坚硬耐磨干撒面层。撒播并打磨施工到新鲜湿润的混凝土地坪上，即形成平滑的彩色耐磨地坪。特别适用于仓库、分销中心、工厂、重型工业设施、飞机库、DIY商场、超市、购物中心、办公室和博物馆。
KETCH0A5floor1 provides a hard wearing, non
–metallic dry shake topping for monolithic
floors. When sprinkled any trowelled into
fresh wet concrete floors, it forms a coloured
, wear resistant smooth surface.
Typical uses are in warehorses,distribution
centers,factories, industrial facilities,
aircraft hangars,DIY stores, supermarkets,
shopping malls, offices and museums.
|
|
返回顶部... |
|
|
|
| |
| 优点 (Characteristics/Adcantages): |
| |
|
* 高度耐磨 (Very high wear resistance)
* 抗冲击性能高 (Impact resistance)
* 节约成本、使用期限长
(Cost effective, long life floor)
* 无需维护 (Maintenance free)
* 防滑 (Slip resistance)
* 防尘 (Dust proof)
* 提高抗油及油脂性能
(Increased resistance to oils
and grease)
* 可选颜色 (Available in colours) |
 |
|
|
返回顶部... |
|
|
|
| |
| 产品数据 (Tests Approval/Standards Product
Data): |
| |
| 形态: |
粉料 |
| 颜色: |
原色（水泥灰）；其他颜色按要求而定 |
| 包装: |
25kg/袋 |
| 储存期: |
原装密封，可保存一年 |
| 储存条件: |
储存于阴凉（+5℃~+30℃）、干燥的地方且防潮 |
| 抗压强度: |
≥90N/mm2 (JC/T 906-2002) |
| 耐磨性: |
Class“AR1”高度耐磨 （BS 8204）?510 (JC/T
906-2002:≥350) |
|
| Conforms to the requirements of British board
of Agrement Certificate No 97/3334 |
| Form: |
Powder |
| Colours: |
Natural(Concrete grey) , Other colours upon
request |
| Packaging: |
25kg bags |
Storage Conditions/
Shelf-Life: |
12 months from date of production if stored
in undamaged original sealed containers in
dry conditions at temperatures between +5℃-and
+30℃ |
|
返回顶部... |
|
|
|
| |
| 施工须知 (Application Details): |
| |
用量
(Consumption): |
约5kg/m2
~5kg/m2 |
基面要求
(Substrate Quality): |
底层混凝土必须质量优良;塌落度须在75~110mm
之间，需采用最小水灰比并在浇捣时完全压实。
抗压强度需在25N/mm 2以上。建议使用ketchment?或ketch?ViscoCrete增塑剂确保最佳的混凝土质量；
若使用纤维则在混合过程中应尽量分散。
The concrete deliveries should be of consistent
qualit. A concrete slump in the range 75
to 110 mm will normally give best results.
The slab should be of good quality concrete
with a minimum water/cement ratio consistent
with the production of a fully compacted
slab.
The compressive strength should be a minimum
of 25 N/mm2.
Use of ketchment or ketch Viscocrete super
plasticisers is advised to ensure the optimum
quality of concrete and where fibres are
used ,maximum dispersion within the mix. |
|
返回顶部... |
|
|
|
| |
| 施工条件和限制 (Application Conditions/ Limits): |
| |
环境温度
(Ambient Temperature): |
最低： +5℃； 最高： +35℃
Min. Ambient temperature;+ 5℃
Max. Ambient temperature;+ 35℃ |
相对空气湿度
(Relative Air Humidity): |
相对空气湿度：30%~98% 湿度较低时注意风干。湿度较高时注意浮浆较慢，凝固、硬化及电动抹光都要减缓。
Rel. Air-humidity;30%-98%
Watch out for efflorescence at low humidity.
Watch out for slow bleeding, slower curing
and hardening and slower powerfloating operations
at high umidities. |
|
返回顶部... |
|
|
|
| |
| 施工指引 (Application Instructions): |
| |
| 施工方法/工具: |
接有激光刮板的自动撒播器；
找平后，立即将ketchfloor 0A5金属地面硬化剂按5kg/m2用量一次性均匀撒播在混凝土上。
手工施工：待表面析出的水蒸发，将ketchfloor?0A5金属地面硬化剂分两次（第一次：3kg/m2；第二次2kg/m2；）
均匀地撒播到找平的混土上。施工粉末时应小心，避免混凝土表面形成坑洼。
施工总用量为5kg/m2。若不注意或向离撒播点2m以外抛洒ketchfloor?0A5，都将减底终面层的一致性。
压实：第一次撒播的材料抹入地板后，立即撒播第二次份量的ketchfloor?0A5。
ketchfloor?0A5使混凝土地坪表面硬化得比平常要快。小心修整将要浇捣的邻接边角。
可用手工或电动刀进行收光，封闭孔隙及修平表面。 |
| 养 护: |
收光后立即用ketchfloor?0A5（参考产品说明书）封闭和养护ketchfloor?0A5。
干撒粉料的施工不应在风或气流太大的地方进行。由于基面混凝土天然的差异，
干撒式硬化剂给混凝土的终饰面有局部色差。通过化学老化，防滑性可以增强。 |
| 养护常识: |
| 基面温度 |
+10℃ |
+20℃ |
+30℃ |
| 可步行 |
18小时 |
12小时 |
8小时 |
| 完全投入使用 |
10天 |
7天 |
5天 |
|
| 上述数值取决于混凝土达到设计的使用强度，并受环境条件变化影响。 |
| 地方限制: |
请注意，由于当地规范不同，不同国家该产品的性能可能会有所差异。请参阅当地的产品说明书关于应用方面授准确描述。 |
| 防护措施: |
在密闭的房间、矿井或竖井内施工，必须保证足够的通风。远离明火，包括焊接。
为避免少量的过敏反应，建议使用丁基或丁晴橡胶手套。更换沾污的工作服，施工间歇和施工完毕要洗手。
必须遵守当地规则和包装标签所示的健康和安全建议。 |
| 注意事项: |
按当地规定处理残留材料。完全固化的材料经当地负责机关同意后，可视同生活垃圾处理。
详细的健康安全信息及预防撒施，如：物理、毒物学、生态学等数据，可参照安全指示说明书。 |
| Application Method/Tools: |
Automatic spreader in conjunction with a
laser screed.
Spread ketchfloor-2 SynTop evenly onto the
concrete immediately after screeding at 5kg/m2
in one application.
Manual application;
Allow the surface bleed water to evaporate.
ketchfloor-2 SynTop onto the screeded concrete
evenly in 2 stages(first stage; 3kg/m2 ;
second stage; 2kg/m2) .care should be taken
to apply the powder to avoid cereating ripples
etc. In the concrete surface. Overall application
rate 5 kg/m2 ; Casting ketchfloor-2 SynTop
Powder carelessly or further hean 2 metres
from point of casting will reduce the consistency
of finish.
Compactiom:
The first stage should be worked into the
slab followed immediately with the sprinking
on of the second measurement of ketchfloor-2
SynTop.
ketchfloor-2 SynTop results in the slab surface
becoming stiff more quickly than usual. Careful
trimming should take place along the edges
where adjoining slabs are to be poured.
Final finishing to close pores and remove
undulations can be achieved either by hand
our powered trowel.
Curing:
Cure and seal ketchfloor-2 SynTop immediately
after fnishing using ketchfloor-Proseal22
(refer to separate producet data sheet).
The application of the dry shake powder should
not be carried out in strong draughts. Dry
shake hardeners give a finish to concrete
with some colour variation from point to
point dre to the matural variability of the
concrete onto which they are applied.Slip
resistance can be enhanced through chemical
ageing. |
Curing Details
Applied product
ready: |
The above values are dependant upon the concrete
reaching its design strength for serviceabilty
and will be affected by changing ambient
conditions.
| Substrate Temperature |
+10℃ |
+20℃ |
+30℃ |
| Foot Traffic |
18Hour |
12Hour |
8Hour |
| Fully Serviceable |
10Day |
7Day |
5Day |
|
| Local restrictions: |
Please note that as a result of specific
local regulations the performance of this
product may vary from country to country.
Please consult the local Product Data Sheet
for the exact description of the application
fields. |
| Protective Measures: |
During application in closed rooms, pits
and shafts, etc, suffcient ventilation must
be provided,Keep away open light including
welding.
To avoid rare allergic reactions, we recommend
the use of butyl rubber / nitril rubber gloves,Change
soiled work clothes and wash hands before
breaks and after finishing work.
Local regulations as well as health and safety
advice on packaging labels must be observed. |
| Important Notes: |
Residues of material must be removde according
to local regulations. Fully cured material
can be disposed of as household waste under
agreement with the responsible local authorities.
Detailed health and safety information as
well as detailed precautionary measures e.g.
physical,toxiclogical and ecological data
can be obtained from the safety data sheet. |
| Legal Notes: |
The information,and in particular, the recommendations
relating to the application and end-use of
ketch products,are given in good faith based
on ketch’s current knowledge and experience
of the products when properly stored, handled
and applied under normal conditions, In practice,
the differences in materials, substates and
actualsite conditions are such that no warranty
in respect of merchantability or of fitness
for a particular purpose, nor any liability
arising out of any legal relationship whatsoever,
can be inferred either from this information,
or from any written recommendations, or from
any other advice offered. The proprietary
rights of third parties must be observed.
All orders are accepted subject to our current
terms of sale and delivery, Users should
always refer to the most recent issue of
the Product Data Sheet for the product concerned,copies
of which will be supplied on request. |
|
